Skip to content Skip to sidebar Skip to footer

How To Do A Wire Tuck

How To Do A Wire Tuck. The best way to hide those ugly wires is to “tuck” them into the fenders. This is the loom you need to cut the wire out of:

GarageB How To Do A Wire Tuck Part 4 (Engine Harness, Wire Labeling
GarageB How To Do A Wire Tuck Part 4 (Engine Harness, Wire Labeling from www.youtube.com

Haven't really seen any how to's on how to do a wire tuck like a step by step process and im interested in doing one. You can then put some small plastic conduit on the wire and tape everything back up, passing it through the large hole. Once you have it lose, you can remove the back of the fuse panel exposing little plugs that attach into the panel.

You Can Then Put Some Small Plastic Conduit On The Wire And Tape Everything Back Up, Passing It Through The Large Hole.


Sep 18, 2011 #2 9!'clipsedohc. Once you have the plugs disconnected, you can now fit the wires through the firewall. This is the loom you need to cut the wire out of:

Just Look At Peoples Builds And Go From There.


Then reinstall the convoluted tubing (i used 3/4, but 1 would of been easier). 4,840 225 aug 24, 2003 el paso, texas. And putting the front end and dash back in.

The Big, Black, Thick Wiring Harnesses That Come Out Of The Firewall Area And Run Along The Top Of The Fenders Are.


Here is a pic of a. Thats pulling the old motor, pulling the dash, and removing the front end. This is a detailed how to wire tuck without having to cut wiring harness up at all!

It Takes Knowing What Goes Where In The Harness, What You Can Eliminate, Running Fresh Wire, Etc.


Haven't really seen any how to's on how to do a wire tuck like a step by step process and im interested in doing one. During my wire tuck i probably hooked the. Its so simple, the best thing to do is just jump right into it.

Take A Razor And Carefully Cut The Two Wires Out Of The Loom Going Back Towards The Firewall Until You Have Enough Wire To Reach The Sensor.


It helps a lot if you can take the engine and harness out of the car because if you want to do it right you will spend a lot of time hooking wires up to sensors, marking where you want to create branches in the loom, taking it all off and looming some, then doing it over again. Im looking for info on how to do a wire tuck on our 2.3 turbos, i want to hide/tuck most if not all wires from the engein bay if posable, was thinking bout running the main harness in the cowl but not sure how to go at it, if anyone has pictures or diagrams or info on how i should go about it thats what im looking for, extending the wires is not a big deal, but doing it to all of the. Each engine and setup is going to be a little.

Post a Comment for "How To Do A Wire Tuck"